Voodoo3 Windows(r) NT 4.0 Driver Kit --------------------------------------- Voodoo3(tm) Driver kit: 1.02.10 Voodoo3 WinNT(r) Display Driver and Miniport: 4.00.1381.0386 Voodoo3 Glide(tm) 2.X Driver: 2.61.00.0437 Voodoo3 Glide 3.X Driver: 3.10.00.0435 Voodoo3 3dfx Tools: 1.4.1.36 OpenGL Driver Version: 1.0.0.0442 ICD Copyright ( 1998-1999 3dfx Interactive, Inc. ) All Rights Reserved NOTE: Use of this software is subject to the terms in the 3dfx license agreement. 3dfx Interactive, Inc. Website: http://www.3dfx.com This product may be covered by one or more of the following US patents: 5,724,561 5,740,343 5,808,621 5,822,452 5,831,624 ======================================================================= What's in the distribution? ======================================================================= This distribution contains Voodoo3 display drivers and control panel for Windows NT 4.0 or higher. ======================================================================= Installation ======================================================================= Requirements ------------ - Windows NT 4.0 - PC with a Pentium II, Pentium Pro, Pentium or similar processor - 16MB of RAM or more Suggested Fresh Installation / Upgrade Existing Drivers --------------------------------------------- 1) Power off the system and remove your existing 2D card. 2) Install the Voodoo3 Card in a free PCI/AGP Slot 3) Power on the system and verify that video appears during post and boot to VGA Mode from Boot Menu 4) Log-in to Windows NT as Administrator. 5) Extract the files for the Voodoo3 driver to a empty temporay directory. 6) Find and run the SETUP.EXE program located in that directory. 7) You may then be prompted to insert the Windows NT Voodoo3 Driver Disk. Enter the path to the drivers again. 8) Reboot the system when prompted. 9) Start Windows NT. If problems occur, revert to "Last Known Good" from within the Windows NT startup options. 10) Delete the directory if desired.